Pendant Project Part 3
Part 3 of the V-Bezel pendant. Today we will finish soldering the pendant I started a couple of days ago, and I have a couple of clean-up tips for you before I get it ready to set the stone.
First I take the setting base and scribe a center line in the back of the half round bezel with Steel Dividers. This is just a location line so I know where to solder the bail. I picked a bail in the last post that had a diamond setting on it, but decided to cut it off because of strength and aesthetic issues. I used Handy Flux, Medium Solder, and my Mini Torch to solder the bail on. I hold the bail with Soldering Spring Tweezers and secure it with a Third Hand Tweezers.
After I solder the bail onto the setting, I clean the back with a Snap on Sanding Disc, make it flush, and add a Sterling Stamp.
I next clean up the edges, making them sharp and crisp. I used a Barrette File, then I wrapped a piece of 600 grit sand paper around the same file and take out the file scratches. I also used a Knife Edge Silicone Wheel and JoolTool 3M Bristle Brushes. These little babies work amazing for taking out scratches.
Now if you have ever wondered how to polish inside places like the inside of a bail, here is a neat trick to get into those hard to get into spots. Get yourself some cotton string, (in different thicknesses) and rub polishing compound on it, now run the string through the bail and tie the other end to your bench. Rub back and forth and it will polish nicely. I use Graystar Compound first, then Red Rouge.
I also polish the tip of a burnishing tool on a piece of paper rubbed with Yellow Rouge and use it to polish the inside of the setting, if the setting base is polished, this will help the stone reflect more brilliantly.
Now the pendant is ready to set and polish. Stay Tuned.
By the way, make sure you subscribe if you haven’t, so you don’t miss ANY JewelryMonk Goodness.
Now go make something Spectacular!
Doug