New Soldering Tip Today PLUS VIDEO

Soldering can be challenging, frustrating, and make you want to throw things……. OR, with the proper guidance, it will be exciting, thrilling, and the joy of your life. One of the things you are going to run into eventually when creating, or working with jewelry, especially casted jewelry is pits. Small pits are one thing and I wrote a post about how to clean them up in an earlier post (www.JewelryMonk.com,pitsandporosity) But today we will look at how to take care of those larger pesky pits.

First, if you have a pit that is too large to cover up with a “Pit-beater” or burnishing tool, you will have to drill it out to make sure there are no hidden inclusions under the pit. There are times when you see a pit, but there could be a much larger pit hidden underneath. Here, I drill out the pit with a .4mm Ball Bur just to make sure I clean the area to be repaired.

Next is a little trick to make sure the solder doesn’t flow where you don’t want it to. I use an anti-flux to prevent this. There are many types of anti-flux, Yellow Ochre Powder is a popular one, “WhiteOut” is also another popular product, but I prefer to make my own. Below is a video where I take a piece of Red Rouge Polishing Compound, scrape off some into a small container and add a drop or two of Mineral Oil. This makes a “slurry” that can be applied with a toothpick. Make sure it stays out of the pit you are going to be soldering.

Click below to see a FREE Video How I make my own Anti-Flux, and you can too, inexpensively.

You can try to add just solder to the pit, but you will more than likely get pits and have solder flow where you do not want it. I like to get a small wire about the size of the pit and add a little solder to the end of the wire. After the solder is carefully melted to the end of the wire, you can heat the piece and add the solder-tipped wire to the ring. I use a Mini Torch to do my soldering.

After the wire is soldered into the pit, trim off the wire with a pair of Semi-Flush Cutters, file, sand, and finish. The anti-flux that was used can be cleaned off in an Ultrasonic Cleaner or with a brass brush or a tooth brush with soap.

There you have it. If you are new to soldering, I would suggest getting some scrap pieces and experimenting with filling pits.  Once you get the hang of this, you will never be intimidated with soldering again.

Thanks for following along, and if you find value in this content, or if you like to keep up to date on the goings-on here, make sure to Subscribe to this Blog Via Email (link in the upper right corner at www.JewelryMonk.com) You can also follow all the “Monkery” on Facebook, Instagram, and Twitter.

Also check out the NEW Tools Section at JewelryMonktools.com

Now, go make something Shiny!

Doug